|
Now that you have purchased your cornice board kits and have determined what window treatments you want, it is time to start the assembly process.
The first step is to get an accurate measurement of the width you need for your project. Measure between the widest two points (either the actual window or the rod length if your cornice board is covering vertical blinds mounted on the wall). Add 1-2 inches on either side to insure that the completed cornice will sit solidly on the wall.
After you have measured twice you are ready to go. First lay out the straight pieces and measure using the measurement you determined in the previous process. Mark the last straight piece to get the exact width you want.
Now let’s start the actual cutting process. Normally you will only need to make one cut per each cornice board you are creating. The next question is what do I use to cut the foam? The following lists the most popular tools to use:
= Hot wire cutter (makes a smooth cut and reseals the foam at the same time, not the most economical tool if you only need one cut. About $20 at JoAnns).
= Any serrated blade knife.
= Hack saw blade.
Let’s cut. Carefully cut the foam using one of the tools above. Once the cut has been made you need to reseal the foam so it glues together correctly. Take the piece with cut end and place a piece of aluminum foil over the end. Use you steam iron and gently tap the foil along the cut (can also use the iron to sooth or level out the foam if your cut was not exactly even). Once this is done pull the foil of the foam and you cut is complete.
Now you are ready to glue the pieces together to create your cornice board kit and you will be ready to decorate.
Come back for future Blogs for addition ideas and tips to create that perfect window décor you have dreamed of. You can also visit http://www.windowbonnets,com/ for further details and watch the instructional video for the entire cornice board assembly process.
Post a Comment