|
Our cornice kits are pre-formed with three contours, the top and bottom are approximately 1/4 the total height of the cornice board with the center being about half. Although the contours or rolls are not super pronounced, I have been asked more than once if we make a "single" contour cornice board. We did try it, but the corners were problematic enough that we felt the success rate for the general public would be relatively low. Our goals in general with the cornice kit was to create a
n easy to assembly, fun to decorate, quick to hang, professional results cornice. The single contour seems to create more frustration than fun. However like all things what is one persons frustration is another's fun challenge. So I introduce you to Rose. A woman who wanted that "single" contour look using a big bold red and multicolored circle pattern! And so take a look at her success. A beautiful kitchen and family room area.
I asked Rose about how she came to this fabric and look, "We wanted a fun room and I always wanted a red and white kitchen so this is a fabric we both could agree on. We both just love the results and have had many compliments already. I’m lucky to be able to enjoy them every day.
She was certainly successful in creating that "single" contour look so I thought it best to let her tell you how she accomplished this... "I used a Barrow Home Decorating Fabric which I purchased on 50% off at JoAnn Fabrics. It was a heavy fabric (reversible) so tucking became a challenge in corners. I tried to clip away as much bulk as possible in those locations to make tucking easier."
"As far as smoothing the fabric, it is best to press your fabric prior to use. Then I laid it flat on a hard surface, put the cornice on top, started tucking in the center (top and bottom both) making sure to pull taunt when tucking and pulling taunt toward each end to smooth. On the circles, you needed to be aware of how the pattern was centered on the cornice and keep it straight. I accomplished this by watching the placement of the circles on the back as I was tucking. Keeping them tucked at the same point on the back kept them straight on the front."
She was certainly successful in creating that "single" contour look so I thought it best to let her tell you how she accomplished this... "I used a Barrow Home Decorating Fabric which I purchased on 50% off at JoAnn Fabrics. It was a heavy fabric (reversible) so tucking became a challenge in corners. I tried to clip away as much bulk as possible in those locations to make tucking easier."
"As far as smoothing the fabric, it is best to press your fabric prior to use. Then I laid it flat on a hard surface, put the cornice on top, started tucking in the center (top and bottom both) making sure to pull taunt when tucking and pulling taunt toward each end to smooth. On the circles, you needed to be aware of how the pattern was centered on the cornice and keep it straight. I accomplished this by watching the placement of the circles on the back as I was tucking. Keeping them tucked at the same point on the back kept them straight on the front.""And most important of all, have some patience, walk away if you get too frustrated, and return to it when you are fresh."
Rose did wonderfully well on her cornices and took our multi-contour cornice form and created her own unique single contour look. She used our 12" high cornice kit throughout her home and you can see the rest of her cornices in our Gallery of Homes-kitchen, dining and family rooms.
In fact, in the kitchen / dining room section is another design that creates that single contour look. Look for the chicken pattern fabric!.
Cheers,
Jan
Post a Comment